Board and batten siding recently installed on our boathouse using cedar boards stained with cabot solid color acrylic deck stain in dark slate.
How to stain board and batten siding.
In this case it is best to forgo the paint and use an exterior stain or sealer instead.
Use a wide paintbrush to apply the stripper to a 2 to 3 foot wide area of the siding.
You should use siding nails to put the battens in place and you will need three and a half inch ones if you can get them.
Check the type of wood if you are painting the siding for the first time on the side of the building.
You should get the primer or stain tinted to match the paint colour you have chosen.
Apply chemical stripper to the siding.
There are many ways to nail board and batten siding.
Some woods such as cedar which are commonly used for board and batten siding do not take well to paint because of the excess oil in the wood.
The most important factor in getting any finish to properly bond to any exterior wood is to not let it be exposed to uv prior to finish enough damage to compromise the final coating can be done in as little as 1 week depending on exposure.
Paint or stain board and batten siding.
Battens which he says he ll finish with a high quality stain.
The nails have to go an inch and a quarter to an inch and a half into the furring strips or.
Writing to fine homebuilding s breaktime forum wenws is looking for some advice on the best way to finish the board and batten siding for his new house.
His plans call for 9 1 2 in.
Allow to sit until the stain begins to lift and bubble.