How To Staple Paper To A Roof

Use a ladder to reach the bottom level of the roof.

How to staple paper to a roof.

Snap chalklines on both sides for guides. Roll out the first section of tar paper over the ice and water shield. Multiply the width by the height for the. Working with a helper unroll the paper so it is about 2 inches below the sill plate and pull it taut.

When you arrive at the rake the paper should be cut flush with a knife and then adjusted to line up with the chalk line. Place a final piece of tar paper over the top of the roof attaching it so it overlaps the tar paper on both sides of the roof. The overhang to the next strip should be 3 8 inch. Unroll paper if you will be attaching the building paper with cap nails use a chalkline to mark the sheathing with the locations of studs.

Step 5 overlap the next strip of tar paper over the first one by 5 inches and staple in place. No matter which valley method you use for extra protection apply wsu at a valley. The idea is to make sure water that falls on the roof drips down from paper to paper and off the roof rather than up under the tar paper potentially damaging the roof s wooden structure. Press into place remove the nails and peel off the paper on the other side.

Begin your first row of tar paper with the bottom of the tar paper. Check that it is level and aligned and drive staples or cap nails. Measure the width and height of each section separately. Fold over the other side and peel off the paper backing.

How to install roofing tar paper. All nails and staples should be placed on the lower half of the paper. Tack it to roof using a hammer stapler or an electric staple gun.