Adjusting slide topper awnings is fairly simple.
How to tighten awning over slide out.
Roll up topper on roller.
If not then repeat the previous steps.
And i ve called and left a message still awaiting the return.
Depending on the make and model there is a different method to adjust the tension.
The roller has a spring in it.
The last step is to reinstall the rv awning.
The slight slack allows water to puddle then as the puddle gets bigger.
Run slide in about 12.
If you are satisfied move on.
Just like that your awning is back in action.
It s best to have three people for this job.
Step 5 re install awning.
Thanks for submitting your question on our ask an rv question page.
I had my slide out awnings installed by the dealer lakeshore rv.
The awning over my slideout is sagging on one end but the other end is tight as both ends should be.
Roll the awning back up to observe how tight it is.
How do you tighten up slideout awnings that are sagging.
If you over tighten the spring it will break.
Dear jim well it depends on the size and make of your slide topper.
You ll be sitting cool in the shade.
Since you do not tell me who manufactured your slideout topper awnings it will be very hard for me to tell you how to adjust the tension on them.
Is there a way to adjust the tension on the end of the awning.
Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total.
Remove end cap or mount.
Here is brad taylor showing how to adjust an awning fabric.
And rvs with slide outs a compartment that extends out from the main cabin providing extra living quarters are sometimes made with awnings over the slide out.
You do not need to put the screws back in.
Usually takes 2 people.
During regular use of your rv the awning fabric and slide in the awning tube causing alignment is.
How to replace spring on awning slideout in rv adjust slide out cover how to tighten loose motorhome slideout covers tightening the spring on a slide out awning slide out kover ii how to adjust spring slide awning toppers tension adjustment how to tighten a carefree slideout topper how tochange the tension on a carefree of colorado.
Make sure it will not fall out.
Many if not most slide toppers have only one spring which is probably the side that is tight.
Put a cotter pin in the hole.
The awning over the big living room slide collects water because there is not enough tension to keep a constant slope.
Roller should now be free of mounting hardware.
In order to get the awning up and stable the tension needs to be adjusted to get the fabric taut.
However perhaps someone here knows how to tighten the slide out awning.
