Installing New Garage Door Torsion Springs

Step 7 carefully test door function.

Installing new garage door torsion springs.

High cycle springs cost 55 to 95 and last two to three times longer than average. After your new door is installed remove the old stop material on the outside of the door and replace it with the type that has a rubber weatherstrip gasket available at home centers. Place the first bar back into the top winding cone and remove the second bar. Remove the locking pliers.

New garage door springs cost 30 to 100 for torsion springs and between 20 and 50 for extension springs without installation. Be sure the springs are solidly attached. Wider and taller doors found in warehouses and commercial facilities use larger torsion springs. Pull down 90 and insert the other winding bar into the cone.

In this video we show how to replace standard garage door torsion springs. Remove the first bar and pull the second bar down 90. Watch the attachment points where the extension springs attach at the back of the door rail. Make sure that the bearing is inside the stationary cone.

The remaining bar should be in an upward position allow it to rest against the wall to hold the door in place. Torsion springs are the most common last longer and are safer to use. Install standard torsion springs install ez set torsion springs ideal door is a leader in residential and commercial garage doors and a preferred brand among consumers architects specifiers and building professionals. Over the past 40 to 50 years the most common type of spring installed on new garage door builds is the torsion spring.

This is the first time the new door is being opened. On doors with two torsion springs each torsion spring should be wound the same number of turns. For doors with torsion springs located over the door spend the 50 or so to have a garage door professional release the tension. Be sure they do not touch the stationary sheaves mounted to the garage door rail just above the garage door opening.

Torsion springs are more common for heavier garage door installations think taller insulated windowed wooden garage doors. Watch the sheaves pulleys that are attached to the end of the extension springs. Finger tighten nuts on bolts until the stationary cone is flush against the center bearing plate.